Kurmachev Yu.F. Design and calculation of a reducing zone of grooves for cold rolling mills for tubes from aluminum alloys

Abstract

The paper discusses the design and calculation of a reducing zone of tube stock from an aluminum alloy during cold tube rolling. Minimum and maximum lengths of the reducing zone were calculated to select its optimal length.

Keywords

Tube, cold tube rolling, reducing zone, reduction ratio.

Kurmachev Yuri Fedorovich – Ph.D. (Eng), Associate Professor, Siberian Federal University, Krasnoyarsk, Russia. E-mail: This email address is being protected from spambots. You need JavaScript enabled to view it..

1. Shevakin Yu.F. Kalibrovka i usiliya pri kholodnoj prokatke trub [Calibration and forces during cold rolling of tubes]. Moscow: Metallurgizdat, 1968, 268 p.

2. Shevakin Yu.F., Gleyberg A.Z. Proizvodstvo trub [Production of tubes]. Moscow: Metallurgy, 1968, 440 p.

3. Orlov G.A. Ways of improving the tool calibration for cold rolling mills of tubes. Stal' [Steel]. 2004, pp. 83-85.

Details: Published: 23 September 2015; Last Updated: 23 September 2015; Hits: 2059